Industrial Electronic Rust Protection Application: Hospital

Industrial Electronic Rust Protection (RSi  Industrial System (Six Channel)) has been upgraded from 4 to 6 channels, so what does this mean? Each channel is an isolated output with the capacity to drive 3 anodes meaning that it can now drive 18 anodes and also if there is a fault with one of the channels, only that channel will go into standby instead of the entire system ensuring that there is not a break in protection. Industrial Electronic Rust Protection is a feature first implemented on the RustStop RS-5 vehicle systems which have 2 channels, but it is even more important on the RSi due to the greater size of the equipment being protected. Acts as anelectronic corrosion inhibitor and electronic rust inhibitor. Industrial Electronic Rust Protection Specifications: Input Voltage220/240 Volt ACCurrent Drawn under DRY Conditions< 0.060ACurrent Drawn under WET Conditions< 0.350ACurrent Drawn under Low Supply Voltage< 0.006AGround(-) Negative (GREEN)HousingHigh Grade ABS PlasticWeight CompleteApprox. 1,450 KilogramsNumber of Channels6Max Anodes per Channel3 in SeriesNumber of Anodes18Output Voltage> 45 VoltsAnode WireNot supplied*Approximate Coverage200m2Anode Wire Specifications: Due to the weight of wiring and variation in what is required per installation, there is no anode wire charged for or supplied with the system. Normally 100m is more than sufficient, however more may be needed for larger structures. As a minimum, the following wire specifications should be used but higher quality wire can be used in very extreme conditions (e.g. silcone insulation, stainless steel conductor core).Industrial Electronic Rust Protection Product Details:Protects up to 200 m2 of Steel per system: The increased number of anodes means more steel can be protected by each RSi system. Each anode can protect up to approximately 12m2 giving total protection to about 200m2 of steel per RSi system.RSi is a modular electronic rust protecto For applications which need protection of more than 200m2 of steel, then multiple RSi systems can be connected in series: Anodes corrode and replaced after 2 yearsRust that would have formed on the steel of the equipment is now transferred onto the anodes as corrosion.Minimum Wire Specifictaions: Multi Strand Panel Flex wireSize: 0.75 mm squareVoltage Rating 500 VNominal Current Rating 3 AStrand No x Diameter: 14 x 0.21Temp.range  10 to 80 degrees CInsulation: Flexible grade PVCFlexibility class 4&5Conductor type: High Conductivity annealed copper